Industry Automation and Drive Technologies - SCE
4.7FB1 Error Information
If an error occurs, ERROR = 1 is set.
The exact cause for the error is indicated in ERRCODE.
Error information
•0000: No error
•1xyz: Internal FB1error
•2xyz: Evaluation device error
•8xyz: Error indications of internal SFCs
Explanation
No error
Impermissible model number (parameter model). The values 1 to 15 are permissible
Impermissible reveive area. Only data type BYTE is permissible
Impermissible data area. Only data blocks are permissble
The receive area does not exist (data block not available)
The receive area is too short
The receive area is write protected
The delay value is outside the permissible range of 0 to 9.999.999us
Selected model number is not trained
Transfer of SFC14 and SFC 15 error indications
No module is configured for the specified logical base address
An access error was detected during the access to the IO
System error at the external PROFIBUS DP interface
4.8Data Block DB10
Tasks of DB10
DB10 is laid out for the structured acceptance/storage of the data from one Main ROI and a maximum of 16
.
TIA Training Document | Page 29 of 47 | Module |
E12 |
|
|
Status: 01/2010 | Vision Sensor Shape Check with SIMATIC | |