Porter-Cable CPLDC2540S instruction manual Before Each Start-Up, How to Start

Page 14

3.Plug the power cord into the correct branch circuit receptacle. (Refer to Voltage and Circuit Protection paragraph in the Installation section of this manual.)

4.Open the drain valve fully (counter-clockwise) to permit air to escape and prevent air pressure build up in the air tank during the break-in period.

5.Move the On/Auto/Off lever to "ON/AUTO" position. The compressor will start.

6.Run the compressor for 20 minutes. Make sure the drain valve is open and there is minimal air pressure build-up in tank.

7.After 20 minutes, close the drain valve (clockwise). The air receiver will fill to “cut-out” pressure and the motor will stop.

The compressor is now ready for use.

Before Each Start-Up:

1.Place On/Auto/Off lever to “OFF”.

2.Pull regulator knob out, turn counter-clockwise until it stops. Push knob in to lock in place.

3.Attach hose and accessories. NOTE: The hose or accessory will require a quick connect plug if the air outlet is equipped with a quick connect socket.

Too much air pressure causes a hazardous risk of bursting. Check the manufacturer’s

maximum pressure rating for air tools and accessories. The regulator outlet pressure must never exceed the maximum pressure rating.

How to Start:

1.Turn the On/Auto/Off lever to “AUTO” and allow tank pressure to build. Motor will stop when tank pressure reaches “cut-out” pressure.

2.Pull the regulator knob out and turn clockwise to increase pressure. When the desired pressure is reached push knob in to lock in place. The compressor is ready for use.

NOTE: Always operate the air compressor in well-ventilated areas free of gasoline or other combustible vapors. If the compressor is being used to operate a sprayer DO NOT place near the spray area.

A02250

14- ENG

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Manual CPLDC2540SSafety Guidelines Definitions Important Safety InstructionsHazard Risk of Explosion or FireRisk of Bursting Risk from Flying ObjectsRisk of Electrical Shock Risk to BreathingRisk of Falling Risk of BurnsRisk from Moving Parts Hazard Risk of Unsafe Operation Duty Cycle SpecificationsGlossary CPLDC2540STo Add Oil To Pump AccessoriesAssembly Allow the Compressor to GET WET Grounding Instructions InstallationLocation of the Air Compressor Improper Grounding can Result in Electrical Shock Extension Cords Voltage and Circuit ProtectionOperation Know Your Air Compressor Description of OperationBefore Starting Motor Thermal Overload Protector not shownHow to Start Before Each Start-UpCustomer Responsibilities MaintenanceTo Check Safety Valve To Drain TankChecking OilAir Filter Inspection and Replacement MotorService and Adjustments To Replace or Clean Check ValveStorage Troubleshooting Problem Cause CorrectionPressure reading Problem Cause Correction Problem Cause Correction Limited Warranty This Warranty is not Transferable and does not Cover
Top Page Image Contents