MAINTENANCE
Customer Responsibilities
| Before | Daily or | Every | Every | Every | Every |
| each | after | 8 | 40 | 160 | 100 Yearly |
| each | |||||
| use | hours | hours | hours | hours | |
| use | |||||
|
|
|
|
|
| |
Check Safety Valve | ● |
|
|
|
|
|
Drain Tank |
| ● |
|
|
|
|
Oil Leaks |
|
| ● |
|
|
|
|
|
|
|
|
|
|
Check Oil |
|
| ● |
|
|
|
|
|
|
|
|
|
|
Change Oil |
|
|
|
|
| ● |
|
|
|
|
|
|
|
Air Filter |
|
|
| ●1 |
|
|
|
|
|
|
|
|
|
1- more frequent in dusty or humid conditions
Unit cycles automatically when power is on. When performing maintenance, you may be exposed to
voltage sources, compressed air, or moving parts. Personal injuries can occur. Before performing any maintenance or repair, disconnect power source from the compressor and bleed off all air pressure.
To ensure efficient operation and longer life of the air compressor outfit, a routine maintenance schedule should be prepared and followed. The following routine maintenance schedule is geared to an outfit in a normal working environment operating on a daily basis. If necessary, the schedule should be modified to suit the conditions under which your compressor is used. The modifications will depend upon the hours of operation and the working environment. Compressor outfits in an extremely dirty and/or hostile environment will require a greater frequency of all maintenance checks.
NOTE: See “Operation” section for the location of controls.
To Check Safety Valve
If the safety valve does not work properly, over- pressurization may occur, causing air tank rupture or
an explosion.
1.Before starting compressor, pull the ring on the safety valve to make sure that the safety valve operates freely. If the valve is stuck or does not operate smoothly, it must be replaced with the same type of valve.
To Drain Tank
1.Set the On/Auto/Off lever to “OFF”.
2.Pull the regulator knob out and turn clockwise to set the outlet pressure to zero.
3.Remove the air tool or accessory.
4.Pull ring on safety valve allowing air to bleed from the tank until tank pressure is approximately 20 psi. Release safety valve ring.
15- ENG | A02250 |