MOTOR TO MOTOR
MOUNTING PLATE
DISCONNECT MACHINE FROM POWER
SOURCE.
Assemble motor (A) to motor mounting plate (B) as shown in Fig. 16. Align the four mounting holes in the motor with the four holes in the mounting plate. Insert a 5/16- 18x3/4" carriage bolt (C), through the hole in motor and then through the hole in the motor mounting plate, place a 5/16" flat washer (D), then a 5/16" external tooth washer (E) onto the carriage head bolt, and fasten with a
NOTE: Do not completely tighten the hex nuts at this time.
MOTOR AND MOTOR MOUNTING PLATE TO SAW
1.DISCONNECT MACHINE FROM POWER SOURCE.
2.Insert a pin (X) Fig. 17, into the holes in each side of bracket (B). NOTE: INSERT THE TAPERED END OF
PIN (X) FIG. 17, THROUGH THE INSIDE HOLE OF BRACKET (B).
3.Assemble spring (Y) Fig. 17, onto the non tapered end of each pin (X) as shown.
4.Position motor and motor mounting plate (A) Fig. 17, below bracket (B) to allow bracket arm to slide through large opening in motor mounting plate (A).
5.Depress pins (X) Fig. 18, on both sides of bracket (B) and rotate motor mounting plate (A) until pins (X) are engaged in holes (D) Fig. 17, of motor mounting plate
(A).
6.Fig. 19, illustrates the motor and motor mounting plate assembled to the rear of the saw.
B
A
C
D |
|
E | F |
| Fig. 16 |
B
X
Y
X
A
Fig. 17
X
B
X
A
Fig. 18
Fig. 19
14