11.Using a straight edge, check to see if the saw blade is aligned with the rear of the splitter (G), as shown in Fig. 37. If alignment is necessary, loosen the screws (A) Fig. 37, align splitter (G) with the saw blade, and tighten two screws (A).
12.Lower saw blade and install table insert (P) Fig. 38,
in the saw table as shown. 
THE TABLE
INSERT SHOULD BE LEVEL WITH THE TABLE SURFACE. IF AN ADJUSTMENT IS NECESSARY, SEE
THE SECTION “ADJUSTING TABLE INSERT”.
When installing the table insert, always make certain to hold on to the blade guard (L). The insert will automatically release the holding action on the splitter and lower the blade guard when it is installed in the table opening.
EXTENSION WINGS
1.Assemble extension wing (A) Fig. 39, to the saw table. Align the three holes in the extension wing with the three holes in the side of the saw table. Place a 7/16" lockwasher (C) Fig. 39, then a 7/16" flat washer (D) on a
2.With a straight edge (E) Fig. 39, make certain the extension wing (A) is level with the saw table before tightening three screws (B).
MODEL 36-649 ONLY
3.Assemble the other sheet metal extension wing to the opposite end of the saw table in the same manner.
MODEL 36-678 ONLY
3. The model |
G
A
Fig. 37
L
P
Fig. 38
D 
C 
D B
extension wing and should be assembled to the left side |
of the saw as shown in Fig. 39. |
MODEL 36-679 ONLY
A
C
3.Assemble the other cast iron extension wing to the opposite end of the saw table in the same manner.
ON/OFF SWITCH
DISCONNECT MACHINE FROM
POWER SOURCE
Insert a
Fig. 39
G
J
FH
B
E
Fig. 40
19