Porter-Cable 36-649, 36-678, 36-675, 36-679 Connecting Motor Cord to Switch Assembly

9. IMMEDIATELY AFTER ASSEMBLING

THE BELT, RAISE THE SAW BLADE TO ITS MAXIMUM HEIGHT AND TILT THE SAW BLADE TO 45 DEGREES. USING A STRAIGHT EDGE (L) FIG. 25, CHECK TO SEE IF THE MOTOR END (J) FIG. 25, IS BELOW THE TOP OF THE TABLE SURFACE (K). IF THE MOTOR END (J) IS ABOVE THE TOP OF THE TABLE SURFACE, THE MOTOR MUST BE MOVED TO THE LEFT UNTIL YOU ARE CERTAIN THE TOP (J) OF THE MOTOR IS BELOW THE TOP OF THE TABLE SURFACE. THEN RE-ALIGN THE MOTOR PULLEY TO THE ARBOR PULLEY.

10.Place a 1/4" flat washer onto the 1/4-20x1-1/2" hex head screw (D) Fig. 23. Place the spacer (F) Fig. 23, onto the 1/4-20x1-1/2" hex head screw (D) Fig. 23, and thread a 1/4-20 hex nut (E) Fig. 23, onto the hex head screw.

11.Align the hole in the outer cover (D) Fig. 26, with the 1/4-20x1-1/2" hex head screw (D) Fig. 23. Place the outer cover (E) Fig. 23, onto the hex head screw. Place a 1/4" external tooth lockwasher onto the hex head screw, thread a 1/4-20 wing nut onto the hex head

screw, and tighten securely. Make certain the outer cover does not interfere with the drive belt and the motor pulley.

CONNECTING MOTOR CORD TO SWITCH ASSEMBLY

1. DISCONNECT MACHINE FROM

POWER SOURCE.

2.Insert the pronged motor plug (A) Fig. 27, into the female receptacle (B) of switch-to-motor cord (C).

3.Fig. 28, illustrates the motor cord connected to the switch assembly.

K L J

Fig. 25

D

E

Fig. 26

B

C

A

Fig. 27

Fig. 28

16