Porter-Cable 36-675, 36-649, 36-678, 36-679 instruction manual

Page 18

8.Assemble the blade guard and splitter assembly (G) Fig. 33, between the large washer (C) and the splitter bracket and tighten screw (H) with wrench supplied.

9.Fasten the rear of the blade guard and splitter bracket assembly (G) Fig. 34, to the rear splitter mounting bracket. Align the hole in the blade guard and splitter bracket with the hole in the rear splitter mounting bracket. Insert a 5/16-18x5/8" carriage head screw through the hole (J) in the blade guard and splitter assembly and through the hole in the rear splitter mounting bracket, place a 5/16" flat washer on the carriage head screw, and fasten with a 5/16-18 hex nut, and tighten securely. IMPORTANT: The splitter (G) Fig. 34, has a notch (L) cut in the top edge as shown. This feature will enable the blade guard to stay in the raised position to make blade changing easier. Raise the front of blade guard (M) Fig. 35, until the rear edge of the blade guard slips into notch (L) of splitter (G); the blade guard will stay in this position.

10.With the blade guard (L) Fig. 36, in the raised position, assemble the saw blade (K) on the saw arbor with two arbor wrenches supplied.

G

C

H

Fig. 33

L

G

J

Fig. 34

M

G

L

Fig. 35

L

K

Fig. 36

18

Image 18
Contents Contractor’s Saw ShownTable of Contents Important Safety InstructionsSafety Guidelines Definitions California PropositionGeneral Safety Rules Important Safety InstructionsStay ALERT, Watch What YOU are DOING, Additional Safety Rules for Table Saws Properly Support Long or Wide workpiecesPower Connections Motor SpecificationsGrounding Instructions Volt Single Phase Operation Extension CordsCarton Contents Functional DescriptionExtension Wings Stand PartsSheet Metal Cast Iron Cast Iron Extension Extension Wings Assembly Tools Required AssemblyUnpacking and Cleaning HardwareStand Legs Stand to SAWBlade Tilting Raising Handwheel Installing Switch Motor Cord Motor and Motor Mounting Plate to SAW Disconnect Machine from Power SourceMotor to Motor Mounting Plate PIN X , Through the Inside Hole of Bracket BMotor PULLEY, Pulley GUARD, and Drive Belt Connecting Motor Cord to Switch Assembly Illustrates the motor cord connected to the switch assemblyBlade Guard and Splitter Assembly and Alignment Page Model 36-678 only ON/OFF SwitchModel 36-649 only Model 36-679 onlyStarting and Stopping SAW Locking Switch in the OFF PositionOperation Overload ProtectionRaising and Lowering Blade Tilting the BladeMiter Gage Operation and Adjustment Adjusting Table InsertTable Insert a should Always be Level with the Table Changing the SAW Blade Open end wrench BNever USE the Fence AS a CUT-OFF Gage When CROSS-CUTTING CROSS-CUTTINGRipping Constructing a Push StickAccessory Moulding Cutterhead Using Moulding CutterheadUsing Accessory Dado Head Using Auxiliary Wood Facing on RIP Fence Power Tool InstituteConstructing a Featherboard Troubleshooting Constructing a Push StickMaintenance ServiceWarranty Model U30 30 Unifence Model DescriptionModel 36-648 30 Fence and Rail System Model BC30 30 Biesemeyer Commercial FenceCanadian PORTER-CABLE Delta Service Centers