Porter-Cable 36-679, 36-649, 36-678, 36-675 Motor PULLEY, Pulley GUARD, and Drive Belt

Page 15

MOTOR PULLEY, PULLEY GUARD, AND DRIVE BELT

1. DISCONNECT MACHINE FROM

POWER SOURCE.

2.

Remove the motor shaft key that is taped to the

motor.

3.

Insert key (A) Fig. 20, in the keyway on the motor

shaft. Assemble motor pulley (B) on motor shaft as

shown, with the hub of the pulley out. Tighten set screw

(C) against key (A) in motor shaft.

4.

Slide the belt and pulley guard bracket (G) Fig. 22,

between the motor plate (A) and motor mounting plate

(C), as shown.

C

A

B

Fig. 20

5. Place a 1/4" external tooth lockwasher onto a 1/4-

20x1-1/2" hex head screw. Insert the screw (D) Fig. 22,

through the hole in the belt and pulley guard bracket (G)

as shown in Fig. 22.

D

G C

A

6.Position belt and pulley guard bracket (G) Fig. 23, so the motor pulley (B) is centered and through the hole in the belt and pulley guard bracket (G), as shown in Fig.

24.Tighten the four hex nuts that fasten the motor to the motor mounting plate.

7.Using a straight edge, align the motor pulley with the arbor pulley. If necessary, adjust the motor pulley (B) Fig. 23, in or out on the motor shaft.

8.Lift up on the motor and assemble the drive belt (H) Fig. 24, to the arbor pulley and motor pulley (B). The weight of the motor will provide the correct belt tension.

Fig. 22

F

D E

B

G

Fig. 23

H

B

Fig. 24

15

Image 15
Contents Shown Contractor’s SawImportant Safety Instructions Table of ContentsCalifornia Proposition Safety Guidelines DefinitionsGeneral Safety Rules Important Safety InstructionsStay ALERT, Watch What YOU are DOING, Properly Support Long or Wide workpieces Additional Safety Rules for Table SawsPower Connections Motor SpecificationsGrounding Instructions Extension Cords Volt Single Phase OperationFunctional Description Carton ContentsExtension Wings Stand PartsSheet Metal Cast Iron Cast Iron Extension Extension Wings Hardware AssemblyUnpacking and Cleaning Assembly Tools RequiredStand to SAW Stand LegsBlade Tilting Raising Handwheel Installing Switch Motor Cord PIN X , Through the Inside Hole of Bracket B Disconnect Machine from Power SourceMotor to Motor Mounting Plate Motor and Motor Mounting Plate to SAWMotor PULLEY, Pulley GUARD, and Drive Belt Illustrates the motor cord connected to the switch assembly Connecting Motor Cord to Switch AssemblyBlade Guard and Splitter Assembly and Alignment Page Model 36-679 only ON/OFF SwitchModel 36-649 only Model 36-678 onlyOverload Protection Locking Switch in the OFF PositionOperation Starting and Stopping SAWTilting the Blade Raising and Lowering BladeMiter Gage Operation and Adjustment Adjusting Table InsertTable Insert a should Always be Level with the Table Open end wrench B Changing the SAW BladeCROSS-CUTTING Never USE the Fence AS a CUT-OFF Gage When CROSS-CUTTINGConstructing a Push Stick RippingUsing Moulding Cutterhead Accessory Moulding CutterheadUsing Accessory Dado Head Using Auxiliary Wood Facing on RIP Fence Power Tool InstituteConstructing a Featherboard Constructing a Push Stick TroubleshootingMaintenance ServiceWarranty Model BC30 30 Biesemeyer Commercial Fence Model DescriptionModel 36-648 30 Fence and Rail System Model U30 30 UnifenceCanadian PORTER-CABLE Delta Service Centers