Porter-Cable
28-248, 28-475X
instruction manual
Troubleshooting
Accessories
Assembly
Adjusting Table Stops
Unpacking and Cleaning
Safety
Power Connections
On / OFF Switch To Stand
Page 26
NOTES
26
Page 25
Page 27
Image 26
Page 25
Page 27
Contents
Wood Cutting Band Saw
Safety Guidelines Definitions
Important Safety Instructions
Stay ALERT, Watch What YOU are Doing
Additional Safety Rules For Band Saws
Power Connections
Functional Description
Unpacking and Cleaning
Band SAW Parts
Motor to Motor Bracket
Assembly
Motor Bracket To Stand
Do not Completely Tighten the Bolt and NUT AT this Time
TOP Plate to Stand
Dust Chute
Only be Attached with the TWO Bottom Holes in the Stand
Stand Door to Stand
Dust Port
Hinge Catch a is Pointed UP AS Shown in FIG
Hinge Opening is Pointing Down
Completely Tighten the Screws AT this Time
Belt to SAW and Motor Pulley
SAW to Stand
Motor Pulley
Is on the Side of the Stand with the Belt Opening B
Table to SAW
Sure the Slot C , in the Table is Facing Away from the ARM D
Length Blades
Blade to SAW
Table Insert
On / OFF Switch To Stand
Starting Stopping SAW
Operating Controls and Adjustments
Locking Switch in the OFF Position
Make Sure That the Motor Plug
Tilting the Table
Adjusting Table Stops
Disconnect Machine from Power Source
Adjusting Blade Tension
To set the adjustable stops
Never Track the Blade While Tool is Running
Vertical Adjustment of the Upper Blade Guide Assembly
Tracking the Blade
Adjusting the Upper Blade Guides and Blade Support Bearing
Cutting Curves
Adjusting Lower Blade Guides and Blade Support Bearing
Operations
Troubleshooting Guide
Probable Cause Remedy
Trouble Blade will not Track
Band SAW Blades
Page
Accessories
PARTS, Service or Warranty Assistance
Canadian PORTER-CABLE Delta Service Centers
Top
Page
Image
Contents