ASSEMBLY
FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.
MOTOR BRACKET
TO STAND
1.Place the stand base on its side as shown in Fig. 6.
2.Align the two holes in the motor bracket (A) Fig. 7, with the two holes in the stand. NOTE: ATTACH
MOTOR BRACKETS TO HOLES #1 AND 3 IN FRONT STAND FLANGE (D) FIG. 6, AND HOLES #2 AND 4 IN BACK STAND FLANGE (E).
NOTE: MAKE SURE THE SLOTS (C) FIG. 7, IN THE MOTOR BRACKET (A), ARE POSITIONED CLOSER TO THE OPENING OF THE STAND (D) THAN THE BACK PANEL (E) OF THE STAND.
3.Insert a
4.Thread a
5.Repeat this process for the remaining hole in the motor bracket.
E
1 2 3 4 5
1 2 3 4
D
Fig. 6
E
C C
D A A
6.Attach the other motor bracket to the stand in the same manner.
MOTOR TO
MOTOR BRACKET
1.Place the motor (A) Fig. 8, on the motor brackets (B). Align the holes in the motor with the holes on the motor bracket.
2.Insert a
3.Thread a
DO NOT COMPLETELY TIGHTEN THE BOLT AND NUT AT THIS TIME.
4.Repeat this process for the three remaining holes in the motor and motor bracket.
Fig. 7
A
BB
Fig. 8
5. Place stand on its base as shown in Fig. 9.
Fig. 9
9