Powermatic 2415, 2013 operating instructions Unpacking, Contents of the Shipping Container

Page 9

Unpacking

Open shipping container and check for shipping damage. Report any damage immediately to your distributor and shipping agent. Do not discard any shipping material until the Band Saw is set up and running properly.

Compare the contents of your container with the following parts list to make sure all parts are intact. Missing parts, if any, should be reported to your distributor. Read the instruction manual thoroughly for assembly, maintenance and safety instructions.

Contents of the Shipping Container

1Band Saw

1Miter Gauge

1Front Rail

1Rear Rail

1Guide Rail

1Fence

1Fence Body

1Combination Wrench - 10/12mm

1Bag of Fasteners, containing:

2 Hex Cap Screws, 5/16-18 x 1-1/4” 4 Hex Cap Screws, 5/16-18 x 3/4” 6 Flat Washers, 5/16”

6 Lock Washers, 5/16”

7 Hex Cap Screws, 1/4-20 x 5/8”

7 Flat Washers, 1/4”

7 Lock Washers, 1/4”

1Owner's Manual

1Warranty Card

Read and understand the entire contents of this manual before attempting set-up or operation! Failure to comply may cause serious injury.

9

Image 9

Contents Vantage Drive Elgin, Illinois Revision C 8/06Copyright WMH Tool Group More Information Warranty and ServiceTable of Contents Electrical Connections Page Page Introduction Specifications Model 2415 shown Features and TerminologyUnpacking Contents of the Shipping ContainerInstalling Fence and Rails AssemblyPage Dust Collection Grounding InstructionsVolt, Single Phase Operation Volt, Three Phase OperationExtension cords Three-Phase Test Run Converting from 230 Volt to 460 Volt Three Phase OnlyAdjustments Table TiltTable Stop Blade Tension Installing/Changing BladesBlade Tracking Upper Blade Guides and Upper Support Bearing Upper Blade Guide AssemblyLower Blade Guides and Lower Support Bearing Belt Tension Miter GaugeBlade Speed Adjustment Operating ControlsBelt Alignment Operation General ProcedureBrake Pedal RippingCrosscutting ResawingBlade Lead Blade Selection Width PitchShape Set MaterialBlade Breakage Maintenance Tire ReplacementBand Wheel Replacement For Radius Cutting Blade Selection GuideTroubleshooting Operational Problems Trouble Verify machine is connected to power Troubleshooting Mechanical and Electrical ProblemsTrouble Probable Cause Remedy Replacement PartsParts List Saw Body Assembly 2013 Band Saw Parts List Saw Body Assembly 2415 Band Saw Saw Body Assembly 2013 Parts List Table Assembly 2013 Band Saw TS-0051061 2013-253TS-0270051 TS-0270061Parts List Table Assembly 2415 Band Saw Index No. Part No Description Size Qty Table Assembly 2013 Parts List Upper Wheel Base Assembly 2013 Band Saw Parts List Upper Wheel Base Assembly 2415 Band Saw Upper Wheel Base Assembly 2013 Parts List Lower Wheel Base Assembly 2013 Band Saw TS-081C032 Parts List Lower Wheel Base Assembly 2415 Band Saw 2415-4262415-426RC Index No. Part No Description Size Qty Lower Wheel Base Assembly 2013 Parts List Guide Bracket Assembly 2013 Band Saw 2013-567 Parts List Guide Bracket Assembly 2415 Band Saw Index No. Part No Description Size Qty Guide Bracket Assembly 2013 Page Page Electrical Connections 230 Volt, 3 Phase Models 2013 Electrical Connections 460 Volt, 3 Phase Models 2013 Page Page WMH Tool Group