Multiquip STX55J6 operation manual STX-SERIES Specifications, This value includes the seat height

Page 11

STX-SERIES — SPECIFICATIONS

Figure 1. STX-SERIES Dimension /Specifications

Table 2. STX-Series Specifications

STX55JDTCSL6

A–Length – in. (cm)

125 (318)

B–Width – in. (cm)

65.0 (165)

C–Height – in. (cm)1

56.0 (142)

Weight – lbs. (kgs.) Operating

2,000 (909)

Weight – lbs. (kgs.) Shipping

2500 (1137)

Sound Pressure – dBA2

97

Vibration – ft/s2 (m/ s2)3

<8.0 (2.5)

Blade Tip Speed – FPM (m/s)

1924 (9.9)

Engine – H.P.

55 John Deere, Diesel Turbocharged

Fuel Tank – gallons (liters)

12 (45)

Rotor – RPM

0 to 130

Path Width – in. (cm)

117 (297)

 

AW MV 684

Hydraulic Oil4

(10W-40 hot weather)

 

(10W-30 cold weather)

NOTE:

1.This value includes the seat height.

2.Sound pressure is a weighted measure. Measured at the operators ear position while the ride-on trowel is operating at full throttle on concrete in a manner most often experienced in “normal” circumstances. Sound pressure may vary depending upon the condition of the concrete. Hearing protection is always recommended.

3.The vibration level indicated is the maximum RMS (Root Mean Square) value obtained at the handle grip while operating the ride-on trowel on curing concrete in a manner

most often experienced in “normal” circumstances.Values were obtained from all three axes of motion. The values shown represent the maximum RMS value from these measurements.

4.“AW” stands for anti-wearand “MV” stands for multi- viscosity.The 68 refers to the general viscosity range and is similar to 10W-30-motor oil. It is recommended that AW MV 68 hydraulic oil be used. If this type of hydraulic oil is not available then use 10W-30 engine oil (cold weather) or 10W-40 engine oil (hot weather).

STX-SERIES • RIDE-ON POWER TROWEL — OPERATION MANUAL — REV. #1 (07/16/04) — PAGE 11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents STX Series RIDE-ON Power Trowel Page Heres HOW to GET Help STX-SERIES Table of Contents Training Checklist STX-SERIES Training ChecklistDaily PRE-OPERATION Checklist STX-SERIES Daily PRE-OPERATION ChecklistDo not follow directions STX-SERIES Safety Message Alert SymbolsEmergencies STX-SERIES Safety Message Alert SymbolsMaintenance Safety General SafetyOperation and Safety Decals STX-SERIES Operation and Safety DecalsThis value includes the seat height STX-SERIES SpecificationsGeneral Information STX-SERIES General InformationToolbox Compartment Storage for tools STX-SERIES Controls and Components FrontSTX-SERIES Controls and Components Rear STX-SERIES Controls and ComponentsFuel STX-SERIES PRE-INSPECTIONPRE-INSPECTION Engine OilStarting the Engine Insert the ignition key into the ignition switch FigureSTX-SERIES Initial START-UP Initial START-UPSTX-SERIES Initial START-UP Oil and Charge Indicator LightsSteering STX-SERIES OperationOperation Push both the left and right joysticks forward Figure STX-SERIES OperationLeft Pitch all the way Down Blade Pitch ControlEngine Shut-Down Failure to allow the engine to idleMaintenance Procedures STX-SERIES MaintenanceMaintenance Matching Blade Pitch for Both Sets of Blades STX-SERIES MaintenanceChanging a Blade Blade Pitch Adjustment BoltPressure Gauge Hydraulic Pump Checking Hydraulic PressureChecking Steering Pressure Steering Pressure AdjustmentPitch Pressure Check Pitch Pressure AdjustmentTroubleshooting STX-SERIES TroubleshootingLights optional not working Lights? STX-SERIES TroubleshootingPage Multiquip INC
Related manuals
Manual 64 pages 22.72 Kb
Top Page Image Contents