Multiquip STX55J6 STX-SERIES Operation, Push both the left and right joysticks forward Figure

Page 19

1.The foot pedal (Figure 13) solely controls blade speed. The position of the foot pedal determines the blade speed. Slow blade speed is obtained by slightly depressing the pedal. Maximum blade speed is obtained by fully depressing the pedal.

STX-SERIES — OPERATION

5.Practice maneuvering the Ride-on Power Trowel using the information listed in Table 3. Try to practice controlled motions as if you were finishing a slab of concrete. Practice edging and covering a large area

6.Try adjusting the pitch of the blades.This can be done with the ride-on trowel stopped or while the trowel is moving, whatever feels comfortable.Test the operation of optional equipment like retardant spray and lights if equipped.

7.Pull both the left and right joysticks backward (Figure 15) and repeat steps 3 through 6 while substituting the word reverse for forward.

Figure 13. Blade Speed Control Foot Pedal

2.Push both the left and right joysticks forward (Figure 14).

Figure 15. Joystick Control Reverse Direction

Trowel Speed Limiter Control

The speed limiter control located on the control panel (Figure 16) can be used to adjust the maximum trowel speed that can be obtained when the foot pedal is fully depressed. Pull up to reduce the maximum speed and push down to return to full speed. For fine adjustments, rotate the knob clockwise or counter-clockwise.

Figure 14. Joystick Control Forward Direction

3.With your right foot, slowly depress the right foot pedal halfway.Notice that the ride-on power trowel begins to move in a forward direction. Release both joystick controls to stop forward movement then remove your right foot from the foot pedal.

4.Practice holding the machine in one place as you increase blade speed. When about 75% of maximum blade speed has been reached, the blade will be moving at proper finishing speed. The machine may be difficult to keep in one place.Trying to keep the ride-on trowel stationary is a good practice for operation.

E

 

 

A

 

LD

S

E

 

HO

HOLD

LOW

Figure 16. Trowel Speed Limiter Control

STX-SERIESRIDE-ON POWER TROWEL — OPERATION MANUAL — REV. #1 (07/16/04) — PAGE 19

Image 19
Contents STX Series RIDE-ON Power Trowel Page Heres HOW to GET Help STX-SERIES Table of Contents Training Checklist STX-SERIES Training ChecklistDaily PRE-OPERATION Checklist STX-SERIES Daily PRE-OPERATION ChecklistDo not follow directions STX-SERIES Safety Message Alert SymbolsEmergencies STX-SERIES Safety Message Alert SymbolsMaintenance Safety General SafetyOperation and Safety Decals STX-SERIES Operation and Safety DecalsThis value includes the seat height STX-SERIES SpecificationsGeneral Information STX-SERIES General InformationToolbox Compartment Storage for tools STX-SERIES Controls and Components FrontSTX-SERIES Controls and Components Rear STX-SERIES Controls and ComponentsFuel STX-SERIES PRE-INSPECTIONPRE-INSPECTION Engine OilStarting the Engine Insert the ignition key into the ignition switch FigureSTX-SERIES Initial START-UP Initial START-UPSTX-SERIES Initial START-UP Oil and Charge Indicator LightsOperation STX-SERIES OperationSteering Push both the left and right joysticks forward Figure STX-SERIES OperationLeft Pitch all the way Down Blade Pitch ControlEngine Shut-Down Failure to allow the engine to idleMaintenance STX-SERIES MaintenanceMaintenance Procedures Matching Blade Pitch for Both Sets of Blades STX-SERIES MaintenanceChanging a Blade Blade Pitch Adjustment BoltPressure Gauge Hydraulic Pump Checking Hydraulic PressureChecking Steering Pressure Steering Pressure AdjustmentPitch Pressure Check Pitch Pressure AdjustmentTroubleshooting STX-SERIES TroubleshootingLights optional not working Lights? STX-SERIES TroubleshootingPage Multiquip INC
Related manuals
Manual 64 pages 22.72 Kb