Multiquip STX55J6 operation manual Checking Steering Pressure, Steering Pressure Adjustment

Page 25

Checking Steering Pressure

Steering pressure is also checked at either of the high pressure diagnostic couplers under the right grill guard. Check steering pressure at either coupler with a 300-600 PSI gauge.

CAUTION

DO NOT depress the FOOT PEDAL with the 300-600 PSI gauge installed or the gauge will be ruined.

Figure 26. Pressure Check Couplers

STX-SERIES — MAINTENANCE

(Table 4) indicates proper steering pressure. Check with engine at Full Speed.

Table 4. Steering Pressure

Checked With Engine at Full Speed

Cool Oil

200-250 PSI

Hot Oil

180-200 PSI

Run the engine at full RPM. The steering system's factory setting is as shown in Table 4, however some operators may prefer a more responsive steering (higher pressure required) and some operators may prefer a "softer feel" (lower pressure required).

Steering Pressure Adjustment

Remember, DO NOT depress the foot pedal with the 300-600 PSI gauge installed. Immediate damage to the gauge will occur.

1.Remove right grill guard.

2.Install 300 or 600 PSI gauge (Figure 27).

3.Loosen 1-1/16" jam nut on charge relief valve (Item A, Figure 28).

4.Use a 1/2" socket to adjust the small hex nut within the larger hex jam nut (Item B, Figure 28).

5.Adjust to proper steering pressure specifications shown in Table 4.

6.Retighten jam nut, remove gauge, and reinstall grill guard.

A

B

Figure 27. Steering Pressure CheckFigure 28. Steering Pressure Adjustment

STX-SERIESRIDE-ON POWER TROWEL — OPERATION MANUAL — REV. #1 (07/16/04) — PAGE 25

Image 25
Contents STX Series RIDE-ON Power Trowel Page Heres HOW to GET Help STX-SERIES Table of Contents Training Checklist STX-SERIES Training ChecklistDaily PRE-OPERATION Checklist STX-SERIES Daily PRE-OPERATION ChecklistDo not follow directions STX-SERIES Safety Message Alert SymbolsEmergencies STX-SERIES Safety Message Alert SymbolsMaintenance Safety General SafetyOperation and Safety Decals STX-SERIES Operation and Safety DecalsThis value includes the seat height STX-SERIES SpecificationsGeneral Information STX-SERIES General InformationToolbox Compartment Storage for tools STX-SERIES Controls and Components FrontSTX-SERIES Controls and Components Rear STX-SERIES Controls and ComponentsPRE-INSPECTION STX-SERIES PRE-INSPECTIONEngine Oil FuelSTX-SERIES Initial START-UP Insert the ignition key into the ignition switch FigureInitial START-UP Starting the EngineSTX-SERIES Initial START-UP Oil and Charge Indicator LightsOperation STX-SERIES OperationSteering Push both the left and right joysticks forward Figure STX-SERIES OperationEngine Shut-Down Blade Pitch ControlFailure to allow the engine to idle Left Pitch all the way DownMaintenance STX-SERIES MaintenanceMaintenance Procedures Matching Blade Pitch for Both Sets of Blades STX-SERIES MaintenanceChanging a Blade Blade Pitch Adjustment BoltPressure Gauge Hydraulic Pump Checking Hydraulic PressureChecking Steering Pressure Steering Pressure AdjustmentPitch Pressure Check Pitch Pressure AdjustmentTroubleshooting STX-SERIES TroubleshootingLights optional not working Lights? STX-SERIES TroubleshootingPage Multiquip INC
Related manuals
Manual 64 pages 22.72 Kb