Multiquip STX55J6 operation manual STX-SERIES Initial START-UP, Oil and Charge Indicator Lights

Page 17

STX-SERIES — INITIAL START-UP

6.Turn the ignition key clockwise to the (start) position. The oil and charge indicator lights (Figure 9) should be on.

Figure 9. Oil and Charge Indicator Lights

In cold weather turn and hold the ignition key counter clockwise to the preheat position, wait until the

NOTE preheat indicator goes off before turning the ignition key clockwise to the start position. Two or three preheat cycles may be necessary in very cold weather.

7.Turn ignition key fully clockwise and listen for engine to start. Once engine has started release ignition key. Let engine warm for a few minutes.

8.Place the engine throttle lever (Figure 11) in the HIGH position.

9.The engine should be running at full RPM.

10.Repeat this section a few times to get fully acquainted with the engine starting procedure.

Figure 10. Engine Throttle Control Lever (High)

STX-SERIES • RIDE-ON POWER TROWEL — OPERATION MANUAL — REV. #1 (07/16/04) — PAGE 17

Image 17

Contents STX Series RIDE-ON Power Trowel Page Heres HOW to GET Help STX-SERIES Table of Contents Training Checklist STX-SERIES Training ChecklistDaily PRE-OPERATION Checklist STX-SERIES Daily PRE-OPERATION ChecklistDo not follow directions STX-SERIES Safety Message Alert SymbolsEmergencies STX-SERIES Safety Message Alert SymbolsMaintenance Safety General SafetyOperation and Safety Decals STX-SERIES Operation and Safety DecalsThis value includes the seat height STX-SERIES SpecificationsGeneral Information STX-SERIES General InformationToolbox Compartment Storage for tools STX-SERIES Controls and Components FrontSTX-SERIES Controls and Components Rear STX-SERIES Controls and ComponentsPRE-INSPECTION STX-SERIES PRE-INSPECTIONEngine Oil FuelSTX-SERIES Initial START-UP Insert the ignition key into the ignition switch FigureInitial START-UP Starting the EngineSTX-SERIES Initial START-UP Oil and Charge Indicator LightsSteering STX-SERIES OperationOperation Push both the left and right joysticks forward Figure STX-SERIES OperationEngine Shut-Down Blade Pitch ControlFailure to allow the engine to idle Left Pitch all the way DownMaintenance Procedures STX-SERIES MaintenanceMaintenance Matching Blade Pitch for Both Sets of Blades STX-SERIES MaintenanceChanging a Blade Blade Pitch Adjustment BoltPressure Gauge Hydraulic Pump Checking Hydraulic PressureChecking Steering Pressure Steering Pressure AdjustmentPitch Pressure Check Pitch Pressure AdjustmentTroubleshooting STX-SERIES TroubleshootingLights optional not working Lights? STX-SERIES TroubleshootingPage Multiquip INC

Related manuals

Manual 64 pages 22.72 Kb