Shipping Bracket
A bracket has been installed to keep the saw in alignment during shipping. Before using your saw you will need to remove it. Store it for safe keep- ing, in the event you move your saw to a different location.
Figure 8. Shipping bracket.
To remove the shipping bracket:
1.Remove the upper hex bolt with a 12mm wrench.
2.Remove the two lower cap screws with a 5mm hex wrench.
Workstop
The workstop on the Model G0592 has three main parts including the workstop rod, arm and work- stop. The workstop is easy to adjust and can be set up on either side of the vise.
To install the workstop:
1.Slide the workstop rod in the hole in the base of the vise and tighten the set screw.
2.Slide the arm onto the workstop rod and tighten the set screw.
Set screw
Arm
Set screw | Workstop Rod |
|
Figure 9. Workstop assembly.
3.Insert the workstop into the arm and secure with the knob.
Workstop | Knob |
|
Figure 10. Workstop.
G0592 Metal Cutting Bandsaw |