SECTION 3: INSTALLATION
Disconnect power to the
!machine when perform- ing any maintenance,
assembly or adjust- ments. Failure to do this may result in serious personal injury.
Mounting
1.Remove the fence and fence rails from your table saw. Remove the left wing of your table saw or the front wing of your shaper. The front and rear fence rails can only extend 1'' past the left side of the machine table. They will require trimming before reinstalling.
2.Attach the upper guide rail to the machine through the extension wing mounting holes. Use the cap screws and spacers supplied and install the spacers between the machine table and upper guide rail. NOTE: The slid- ing table is supplied with two different size
Figure 2. Aligning the upper rail.
G4227 Sliding Table
Always wear safety glasses throughout the entire assembly process. The use of a hand drill is necessary and chips will be propelled into the air which may lead to seri- ous personal injury.
mounting cap screws,
1.50 x 55mm. If your machine has a different thread than listed here, you will need to obtain bolts from your local hardware store. Make sure the threaded portion is at least 23⁄8'' long.
3.Adjust the upper guide rail 1⁄8'' below the sur- face of your machine’s table. Measure from the upper rail to the floor at both ends to achieve parallelism. Tighten the cap screws when the rail is properly adjusted. Figure 2.
4.To mount the lower guide rail bracket, refer to the drill guide sheet on page 14 for prop- er hole locations. Drill two pilot holes using a 1⁄8'' drill bit then finish with a 3⁄8'' drill bit. Figure 3. Please note that Grizzly machines are