Introduction, Safety Rules, Commentary

SECTION 2: INTRODUCTION

Safety Rules

1.TEST THE STABILITY OF THE MACHINE BEFORE USING. An extended or heavy load may alter the balance point of the machine (especially if used with a mobile base). Neglecting this step could result in damage to the equipment and serious injury to the operator.

2.KEEP FINGERTIPS AWAY FROM THE MOVING BLADES OR CUTTERS.

3.ALWAYS FEED THE WORK AGAINST THE DIRECTION OF ROTATION.

4.USE A DUST MASK OR RESPIRATOR, even if you have a reliable method of dust collection, when cutting or shaping, as well as EYE AND EAR PROTECTION.

5.DO NOT CUT IT if there is any doubt as to the stability or integrity of the material to be cut. Look for loose knots, nails and any defect that may cause the workpiece to shift, come apart or cause blade failure.

6.DO NOT EXTEND FINGERS BELOW THE BOTTOM OF THE FENCE NEAR THE STA- TIONARY TABLE. A potential for pinched fingers exists.

7.AVOID KICKBACKS (work thrown back toward you) A condition in which a piece of wood is thrown back towards an operator at a high rate of speed. If you do not have a complete understanding of how kickback occurs, or how to prevent it, DO NOT oper- ate this table saw.

8.IF AT ANY TIME YOU ARE EXPERIENC- ING DIFFICULTIES performing the intended operation, stop using the machine! Then contact our service department or ask a qualified expert how the operation should be performed.

9.HABITS - GOOD AND BAD - ARE HARD TO BREAK. Develop good habits and safe- ty will become second nature to you.

Commentary

Grizzly Industrial, Inc. is proud to offer the Model G4227 Sliding Table. The Model G4227 is part of Grizzly’s growing family of fine woodworking and metalworking tools. When used according to the guidelines stated in this manual, you can expect years of trouble-free, enjoyable operation.

The Model G4227 Sliding Table provides your full-sized table saw or shaper with increased pre- cision and convenience when milling or cross- cutting larger wood panels and flat stock. The Model G4227 Sliding Table is designed to fit the Grizzly Model G1023-series Table Saws, Model G1026 and G1035 Shapers and most other full- sized saws and shapers.

We are also pleased to provide this manual with the Model G4227. It was written to guide you through assembly, review safety considerations, and cover general operating procedures. It repre- sents our effort to produce the best documenta- tion possible. If you have any comments regard- ing this manual, please write to us at the address below:

Grizzly Industrial, Inc.

C⁄O Technical Documentation

P.O. Box 2069

Bellingham, WA 98227-2069

-4-	G4227 Sliding Table