5.Install the lower guide rail bracket to the stand/cabinet, using the two
Figure 4.
Figure 4. Mounting lower guide rail bracket.
6.Thread the mounting studs into the lower rail approx. 1⁄2''. Attach the lower rail to its mount- ing bracket. Figure 5.
Figure 5. Mounting the lower rail.
7.Adjust the lower rail so its centerline is approximately even with the edge of the upper guide rail bracket. Figure 6.
Figure 6. Lower rail alignment.
8.With the sliding table upside down, mount the guide bearing bracket arm using the four 1⁄4''-20 x 3⁄4'' cap screws, flat washers and lock washers provided. Figure 7. Lift up on the bracket arm while tightening to ensure the cap screws will be at the end of the slot. If this detail is overlooked, the head of the cap screws will not allow the fence to swing to 45˚.
Figure 7. Mounting the bracket.
G4227 Sliding Table |