Figure 12.
14.Now loosen the eccentric roller shaft nuts slightly and rotate the eccentric shafts until the sliding table is about 1⁄16'' above the machine table. Tighten the nuts down and recheck the sliding table height. Fine tune the table height by turning the upper grooved roller eccentric shafts without loosening the nut. Figure 13.
Figure 13. Roller adjustment.
15.Raise the pinch rollers back up and tighten the nuts. Roll back the eccentric slightly if the table travel is stiff.
16.Mount the fence by sliding the plastic T-nuts into the bottom of the fence. Insert the short stud into the hole closest to the machine table, the longer stud with spacer goes through the sliding mount. Figure 14. Install the lock handles from below.
-12-
Figure 14. Mounting the fence.
17.Set the sliding table fence so it extends to the saw blade or shaper fence. Figure 15. Loosen the lower bearing guide shaft nut and rotate the eccentric shaft from below the bearing until the end of the fence almost touches the machine table. Retighten the nut. NOTE: If the eccentric does not provide sufficient travel, the threaded mounting studs on the lower guide rail assembly can be adjusted by turning the nuts on either side of the bracket.
Figure 15. Adjusting the lower guide.
G4227 Sliding Table