9.Slide the table mechanism onto the rails. Adjust the lower bearing guide until it is cen- tered on the lower guide rail as in Figure 8. Please note: the upper grooved rollers can be easily derailed at this point (see Figure 12).
Figure 8. Adjust lower guide bearing.
10.Slide the rubber ring onto the front rail and install the front stop assembly. Figure 9.
Figure 9. Front stop installation.
11.Install the rear stop using the #10-24 x 3⁄4'' Phillip head screw provided. Figure 10.
Figure 10. Rear stop installation.
12.Slightly loosen the lower front and rear pinch roller nuts with a 14mm wrench. Now turn their eccentric shafts with a 17mm wrench until they are at their lowest position. Figure 11.
Nut
Eccentric
Figure 11. Lower pinch roller adjustment.
13.Prior to adjusting the upper eccentric grooved rollers, it must be understood that the grooved rollers need to remain in full contact with the upper rail during the adjust- ment process in order to achieve proper adjustment. Figure 12.
G4227 Sliding Table |