Working Table
The table secures to the trunnion support which mounts to the body casting. The trunnions are premounted to the table.
To mount the table and trunnion support:
1.Remove the three table bracket mounting bolts from the bandsaw body. Figure 11 shows them removed.
Trunnion Support Mounting Holes
Figure 11. Trunnions removed from bandsaw.
2.Place the trunnion support on the body cast- ing over the mounting holes, and secure it with the three bolts you just removed, mak- ing sure the support is placed so that the blade is centered between the guide-block brackets.
3.Release tension and remove blade. Refer to ÒBlade ChangesÓ instructions if you need help. Position the table so that the miter slot will be to the right of the blade as you face the front of the bandsaw.
4.Orient the trunnion bolts under the table so they hang vertically.
5.Set the table trunnions onto the support. Make sure the trunnion bolts drop through the trunnion support slots.
6.Secure the table to the trunnion supports by tightening the two star knobs onto the trun- nion bolts shown in Figure 12.
Table Pin
Trunnion
Trunnion Trunnion
Support
Star Knobs
Figure 12. Under table controls.
7.Place the table insert in the table top and slide the table pin so it fits snugly in the hole on the right side of the table. DO NOT use excessive force.
NOTICE
The tapered table pin must be in position when operating the bandsaw.
G1073/G1073Z 16" Bandsaw |