SECTION 7: MAINTENANCE
GeneralBearings
Regular periodic maintenance on your Model G1019 Bandsaw will ensure its optimum perfor- mance. Make a habit of inspecting your bandsaw each time you use it. Check for the following con- ditions and repair or replace when necessary.
1.Loose mounting bolts.
2.Worn switch.
3.Worn or damaged cords and plugs.
4.Damaged
5.Any other condition that could hamper the safe operation of this machine.
Always perform any maintenance with the power off and the machine unplugged.
Table
The table and other
Some woodworkers recommend using automo- tive paste wax on exposed steel and cast iron surfaces. The wax provides a layer of protection, as well as reducing friction between lumber and the table, making cuts faster and smoother. Avoid waxes that contain silicone or other synthetic ingredients. These materials can find their way into lumber that’s being worked, and can make staining and finishing difficult. If you use paste wax, make sure that it’s 100% Carnauba wax.
Since all bearings are shielded and permanently lubricated, no maintenance is required on them. If after a period of time you notice a distinct noise or rumble coming from a shielded bearing, or the bearing journal is hot to the touch after use, it will be time to replace the shielded bearing assem- bly(s). Please contact our Customer Service num- ber to order replacement bearings or to make arrangements to send your bandsaw back for ser- vice.
Inspect
Disconnect power to the machine when perform- ing any maintenance or assembly. Failure to do this may result in serious personal injury.
G1019 14'' Bandsaw |