Grizzly G1019 instruction manual Cross Braces

2.Stand the panels up so the rubber feet are on the floor. Attach two cross braces to one of the side panels using (4) 1⁄4''-20 x 1⁄2'' car- riage bolts, flat washers and hex nuts pro- vided. Next, attach the other side panel to the cross braces already mounted. See Figure 4. Note: Do not tighten any fasten- ers at this time.

Cross Braces

Figure 4. Attach cross braces.

3.Now, turn the stand over and attach the motor support plate using (4) 5⁄16''-18 x 3⁄4'' hex bolts, (8) washers and (4) hex nuts. See Figure 5.

Motor

Support

Plate

Figure 5. Install motor support plate.

4.Turn the stand right side up and attach the motor mount plate to the motor mount sup- port plate using (4) 5⁄16"-18 x 3⁄4" hex bolts,

(8)flat washers and (4) hex nuts. See

Figure 6.

Motor

Mount

Plate

Figure 6. Add motor mount plate.

5.Mount the double bend brace to the motor mount plate. Use (2) 5⁄16''-18 x 3⁄4'' hex bolts,

(8)flat washers and (2) hex nuts. See

Figure 7.

Double

Bend

Brace

Figure 7. Mount double bend brace.

G1019 14'' Bandsaw -11-