Handwheel
One handwheel has been removed for shipping. To install, place the handwheel over the threads and screw the lock knob into the center. Next insert the handle into the handwheel and tighten it as shown in Figure 14. Install the other handle onto the other handwheel.
Figure 14. Installing handle on handwheel.
2.Ensure that all four setscrews are firmly in contact with the table casting.
3.Using a 6mm hex wrench, raise or lower each of the four setscrews shown in Figure 15 until the insert is flush with the table top. Use a straightedge to make sure the table insert is flush with the top of the table.
4.Now make sure the blade will not come into contact with the table insert. Position the blade at 90¡, then raise and lower the blade through its full range of motion. Also, rotate the blade, making sure that the blade never contacts any part of the table insert. Do the same with the blade in the 45¡ position. Wear leather gloves while rotating the blade to pre- vent being cut.
NOTICE
The table insert must be flush with the top of the table or the workpiece will hit the edge of the table insert at the beginning of the cut.
Table Insert
Disconnect power to the machine when perform- ing any maintenance, assembly or adjust- ments. Failure to do this may result in serious personal injury.
The table insert provides access to the blade and the arbor when removed. When in place, the insert provides support for the materials being cut.
1.Disconnect the power cord from the outlet!
Figure 15. Setscrews on each corner of insert.
G1023SL/G1023SLX |