SECTION 4: ASSEMBLY
Keep clothing rolled up and out of the way of machinery and keep hair pulled back.
Disconnect power to the machine when perform- ing any maintenance or assembly. Failure to do this may result in serious personal injury.
Wear safety glasses dur- ing the entire assembly process. Failure to com- ply may result in serious personal injury.
Some metal parts may have sharp edges on them after they are formed. Please examine the edges of all metal parts before handling them. Failure to do so could result in injury.
Most of your Model G1023SL/G1023SLX has been assembled at the factory, but some parts must be assembled or installed after delivery. We have organized the assembly process into steps. Please follow along in the order presented here.
TOOLS REQUIRED: You will need a high quality square, a long straightedge, 10mm, 12mm, 14mm open end wrenches and a 3mm Allen¨ wrench.
Extension Wings
Inspect the extension wings for burrs or foreign material that may inhibit assembly. The mating edges of the wings and the table must be clean, smooth, and flat. Use a wire brush or file if nec- essary to clean up the edges. For the Model G1023SLX, only follow the left wing instructions.
The table and the wings represent a very heavy load. DO NOT
1.Attach the left wing to the table using the three hex head bolts and the flat washers provided. Adjust the wing reasonably flush with the table. Do not tighten the bolts.
2.Attach the right wing to the table using the three hex head bolts and the flat washers provided. Adjust the wing reasonably flush with the table. Do not tighten the bolts.
3.Align the top of the wing flush with the table top directly above the front bolt, and tighten the front bolt. The front edge of the extension wing should also be flush with the front edge of the table.
4.Raise or lower the rear of the extension wing until the middle of the wing is flush with the table top. Tighten the middle bolt.
5.Raise or lower the rear of the wing until the wing and table are flush. Tighten the bolt. Any adjustment at this point should be mini- mal.
6.Check flushness over the front bolt and re- adjust if necessary.
7.Repeat Steps
G1023SL/G1023SLX |