Grizzly G1023SLX, G1023SLWX Lubrication, To adjust V-belt tension, To replace the V-belts

To adjust V-belt tension:

1.Loosen the motor mount bolt.

2.Shift the motor up or down to increase or decrease the V-belt tension. Tighten the motor mount bolt.

3.Check the V-belt tension again. Ensure that the motor pulley and arbor pulley are lined up.

To replace the V-belts:

1.Remove the blade.

2.Adjust the arbor so it is up all the way and in the 90¡ position.

3.Place a board under the motor and loosen the motor mount bolt. Slowly lower the arbor until the motor rests on the board, allowing the belts to be loose on the pulleys.

4.Pull off the old V-belts and replace them with new ones. Have the number from the belt ready when calling the service department for replacements.

5.Raise the arbor and remove the board to adjust the V-belt tension.

6.Tighten the motor mount bolt.

Keep clothing rolled up and out of the way of machinery and keep hair pulled back.

Wear safety glasses dur- ing the entire mainte- nance process. Failure to comply may result in serious personal injury.

Lubrication

Lubricate the areas indicated below every 12 months.

1.Blade angling trunnions. These should be lubricated with 6 or 7 drops of light machine oil.

2.Blade height trunnion. This should also be lubricated with 6 or 7 drops of light machine oil.

3.The two (2) worm gears should be lubricat- ed with an automotive wheel bearing grease.

These points can be reached by removing the table. Check all adjustments when finished lubri- cating.

G1023SL/G1023SLX Left-Tilting 10'' Table Saw -35-