USING SETUP MODE

Procedure

Before adjusting a print position, you should carefully measure the amount of adjustment required for any paper that demands precise print registration. To adjust a print position, make sure that continuous forms paper is loaded. The following example shows how to adjust the top-of-form setting for continuous forms.

1.Enter setup mode.

Press the TEAR OFF button and the ONLINE button simultaneously until the printer beeps. Wait for the printer to stop printing and check that the following <<FUNCTION>> menu is printed:

<<FUNCTION>>

SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG DEFAULT LIST SELF-TST HEX-DUMP V-ALMNT

2. Select the ADJUST function.

Reference

Quick

 

 

 

 

Introduc-

 

 

 

 

 

Setting

 

Up

 

 

 

Repeatedly press the LOAD button or the LF/FF button to position the red cursor under ADJUST. Press the MENU button or the TEAR OFF button to select the ADJUST function and print the following <CNT-ORG> options:

Handling

Paper

<CNT-ORG>

 

 

 

 

 

 

 

 

 

1/6IN

1.8/6IN

2/6IN

3/6IN

4/6IN

5/6IN

6/6IN

7/6IN

8/6IN

9/6IN

10/6IN

11/6IN

....

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

3. Select an option from 1/6IN to 66/6IN.

Printing

Press the LOAD button or the LF/FF button to move the cursor to the required option. Press the MENU button to select the option and print the <CNTFINE> item. If necessary, fine-tune the top-of-form position now. Otherwise, go to step 4.

4. Exit the ADJUST function.

SetupMode

Press the ONLINE button to exit the ADJUST function and reprint the <<FUNCTION>> menu.

User's Manual

5-39

Page 117
Image 117
Fujitsu DL3750+/3850+ manual Select the Adjust function, Select an option from 1/6IN to 66/6IN, Exit the Adjust function