Fujitsu DL3750+/3850+ manual Changing, Configuration Options, Config Items and Options

USING SETUP MODE

5.Exit setup mode, saving the top-of-form setting.

Make sure that the red cursor is positioned beneath SAVE & END, then press the MENU button or the TEAR OFF button.

6.Check the top-of-form setting.

Load your paper and check the adjustment by printing a sample page using your software. If necessary, reenter setup mode and fine-tune the top-of-form position by changing the <CNTFINE> option.

CHANGING	The CONFIG function defines the printer’s primary configuration. You can
CONFIGURATION OPTIONS	set the following options to ensure that the printer meets your requirements:
	• Tear off for continuous forms
	• Autoloading of single sheets
	• Direct decoding of certain commands
	• Enabling of the AREA OVER indicator
	Table 5.6 describes the CONFIG items and options. Items are listed in the
	order they are printed. The procedure for changing the configuration options
	is described after Table 5.6.
	Table 5.6 CONFIG Items and Options
	NOTE: Underlined options are the factory defaults.
	CONFIG Items	Options	Description
	<TEAROFF>		Auto or manual tearoff feed.
		MANUAL	Automatic tearoff feed is invalid,
			and tearoff feed must be done using the
			TEAR OFF button.
		AUTO	Automatic tearoff feed is valid but only
			for continuous forms. Tearoff feed can
			also be done using the TEAR OFF
			button.

5-40 User's Manual