Fujitsu DL3750+/3850+ manual Testing the Printer, Offline, Loading Paper for the Self-Test

SETTING UP

TESTING THE PRINTER	At this point, load paper and run the printer self-test. The self-test checks
(OFFLINE)	printer performance and print quality before you connect the printer to the
	computer. Use either single sheets or continuous forms (see Chapter 3). This
	section describes the self-test procedure using single sheets.
	Loading Paper for the Self-Test
	To print the self-test, use paper wider than 215.9 mm (8.5 inches) and set the
	left paper guide all the way to the right to avoid clipping the test pattern.
	Standard letter or A4 size paper can be used lengthwise (portrait mode).
	Before loading paper, make sure that the printer is on. Then, proceed as
	follows:
	1. Make sure that the paper thickness lever (located on the top right of
	the printer) is at position 1. Make sure that the paper select lever
	(located on the top left of the printer) is set to the front, as shown
	below.

Reference	Quick
Introduction
SettingUp
Handling	Paper
Printing
SetupMode

Loading a sheet of paper

User's Manual 2-13