Fujitsu DL3750+/3850+ manual Paper Thickness Lever Settings, Using Single Sheets

PAPER HANDLING

Table 3.2 Paper Thickness Lever Settings

Number of Copies	Setting *2
(Including the Original) *1
1 copy	1
2 copies	2
3 copies	3
4 copies	4
5 copies	5
Ribbon replacement	D

*1 For carbon-interleaved paper, the carbon counts as one copy.

*2 Vary the setting up or down (including A to D) to optimize printing. Select D when replacing a ribbon or clearing a paper jam. For labels and envelopes, use trial-and-error to determine a satisfactory setting.

NOTE

If printing is messy, the ribbon misfeeds, or the paper jams, move the

lever one setting higher.

USING SINGLE SHEETS	This section describes how to load paper in the cut sheet stand.
	The cut sheet stand allows paper to be loaded manually, one sheet at a time.

Loading a Single Sheet of Paper

To load a sheet of paper into the cut sheet stand:

1.Make sure that the printer is turned on. Check that rear-fed continu- ous forms are retracted to the park position. (For details, see the section Unloading Continuous Forms later in this chapter.)

Reference	Quick
Introduc-
Setting
Up
Handling	Paper
Printing
Setup
Mode

User's Manual 3-5