Fujitsu DL3750+/3850+ manual Online Setup Mode

USING SETUP MODE

ONLINE SETUP MODE	The preceding sections describe offline setup mode. This section introduces
	online setup mode. The tedious task of setting up printer features one-by-one
	from the control panel and printing and checking the desired options on paper can
	be avoided by using online setup mode. In online setup mode, printer features are
	set via the computer rather than the printer control panel.
	Put the printer in online setup mode, in either of the following two ways:
	• Turn the printer off and then turn the printer back on while pressing
	the MENU button. Hold down the button until the printer beeps.
	• Issue the printer command ESC e ONLINE. This command is valid
	in any emulation.
	Send setup data from the computer in any of the following three ways:
	• Enter setup data directly from the computer keyboard before starting
	your job. With MS-DOS, hold down the Ctrl key and type P. Data
	entered from the keyboard is sent directly to the printer. When data
	entry is complete, hold down the Ctrl key again and type P. This
	method is useful when just a few settings need to be changed.
	• Use an editor program to prepare a setup data file and then send the
	file to the printer using a command before starting your job. With
	MS-DOS, use the COPY command. This method is useful when
	settings are used repeatedly.
	• Write a program that enables interactive entry of setup data on the
	CRT screen. This method is the most useful of the three. Check with
	your dealer for currently available programs.
	To exit from online setup mode, send EXIT as the last setup data.
	For details of setup data and its format, refer to the programmer's manual for
	each emulation.

5-62 User's Manual