Fujitsu DL3750+/3850+ Using the Diagnostic Functions in Chapter, Section Changing MENU1 and MENU2

TROUBLE-SHOOTING

Table 7.1 Print Quality Problems and Solutions (Cont.)

Problem	Solution
Printing is	Use the printer’s V-ALMNT function to
vertically	check the vertical print alignment. If necessary,
misaligned	adjust the print alignment. See the section
(jagged).	Using the Diagnostic Functions in Chapter 5.
The top margin is	The top margin is the sum of the top-of-form
wrong.	setting, the software-specified top margin, and the
	printer’s TOP-MRG setting. Proceed as follows:
	• Make sure that the top-of-form setting is
	correct. The factory default is 25.4 mm (1
	inch). See the section Changing Top-of
	Form in Chapter 5.
	• Check the software-specified top margin.
	Refer to your software documentation.
	• Check the printer’s TOP-MRG setting. See
	the section Changing MENU1 and MENU2
	Options in Chapter 5.
Lines are double	Check the line spacing setting in your software.
spaced instead of
single spaced.	Change the CR-CODE setting in the printer setup
	mode to CR ONLY. See the section Changing
	MENU1 and MENU2 Options in Chapter 5.
The printer	Change the CR-CODE setting in the printer
overprints on the	setup mode to CR & LF. See the section
same line.	Changing MENU1 and MENU2 Options in
	Chapter 5.
The next print line	Change the LF-CODE setting in the printer
starts where the	setup mode to LF & CR. See the section
previous line	Changing MENU1 and MENU2 Options in
ended instead of	Chapter 5.
at the left margin.

shooting Trouble-

User's Manual 7-3