Fujitsu DL3750+/3850+ manual Adjusting the left margin, Preparing to load a sheet of paper

PAPER HANDLING

2.If necessary, reset the paper thickness lever. (See the section Adjusting for Paper Thickness earlier in this chapter.)

3.Move the paper select lever forward. (This lever is at the top left of the printer.)

4.Raise the cut sheet stand. Position the left paper guide. Note that its movable range is limited.

Adjusting the left margin

Below the left paper guide, the cut sheet stand has a scale graduated in units of

0.1inch. When the left paper guide is positioned all the way to the right, the left margin is approximately 5 mm (0.2 inch). To help align paper, also use the two inch-based rulers on the ejection cover of the printer. The gradations on the ruler are for 10 columns per inch.

Left margin (minimum)

Preparing to load a sheet of paper

5.Insert a sheet of paper into the cut sheet stand. Make sure that the bottom edge of the paper engages snugly with the platen. Adjust the right paper guide.

3-6 User's Manual