USING SETUP MODE

1.Enter setup mode.

Press the TEAR OFF button and the ONLINE button simultaneously until the printer beeps. Wait for the printer to stop printing and check that the following <<FUNCTION>> menu is printed:

<<FUNCTION>>

SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG DEFAULT LIST SELF-TST HEX-DUMP

V-ALMNT

2.Select the DEFAULT function.

Repeatedly press the LOAD button or the LF/FF button to position the red cursor under DEFAULT. Press the TEAR OFF button or the MENU button to select the DEFAULT function. The printer reprints the <<FUNCTION>> menu. The default values in MENU1 and MENU2 are now reset.

3.Do either of the following:

Select new options for MENU1 or MENU2.

Exit setup mode, saving the factory defaults.

See the section Changing MENU1 and MENU2 Options. To exit setup mode and save the new defaults, make sure that the red cursor is positioned under SAVE & END, then press the TEAR OFF button or the MENU button.

USING THE DIAGNOSTIC

This section describes how to use the following diagnostic functions:

FUNCTIONS

 

 

 

SELF-TST

 

HEX-DUMP

 

V-ALMNT

These functions are used for checking print quality and diagnosing printer problems. HEX-DUMP also provides useful information for programmers.

5-50

User's Manual

Page 128
Image 128
Fujitsu DL3750+/3850+ manual Using the Diagnostic, Functions, Select the Default function