Fujitsu DL3750+/3850+ manual Setting UP

SETTING UP

4.Use your software printer selection menus or the printer setup mode (described in Chapter 5) to make required changes in the page layout or other print features.

If the printer does not print or prints the wrong characters, proceed as follows:

•Make sure that the interface cable is properly connected.

•Make sure that the printer emulation selected in your software is the same as that selected on the printer.

•If you are using a serial interface, make sure that the printer

serial interface settings are the same as those on the computer. The printer’s preselected factory settings are 8 data bits, no parity, 1 stop bit, 9600 baud, and XON/XOFF protocol.

You can change the serial settings on either the printer or your computer. To change the printer settings, see Chapter 5. To change the computer settings, use the selection menus provided by your software or the commands of your computer operating system. The following example uses the MS-DOS operating system:

Reference	Quick
Introduction
SettingUp
Handling	Paper
Printing
SetupMode

User's Manual 2-27