Fujitsu DL3750+/3850+ manual Cont-Pe, Tractor, Edge, Gather

USING SETUP MODE

Table 5.6 CONFIG Items and Options (Cont.)

NOTE: Underlined options are the factory defaults.

CONFIG Items	Options	Description
<CONT-PE>		Detection of end of continuous forms.
	TRACTOR	Paper end is detected by the sensor on
		the tractor unit.
		Paper-end unprinted area:
		Continuous forms: About 80 mm
	EDGE	Regardless of paper end, printing
		continues near to the edge of paper.
		Paper-end unprinted area:
		About 4.7 mm for both continu-
		ous forms
GATHER		Setting of ribbon protective control
		at a line feed on continuous forms
	ENABLE	The protective control is executed.
	DISABLE	The protective control is not
		executed.
CUT-CTL		Setting of retracting control at
		canceling TEAR OFF of continuous
		forms.
	PRCISIN	The precision-prioritized retracting
		control is executed.
		It retracts a certain amount of paper
		(the top part of the paper which
		hangs out from the TOFS), and then
		moves back to the position before
		TEAR OFF. If TOFS detects paper
		end when a certain amount of paper
		is retracted, it executes the continu-
		ous forms save operation and then
		executes the paper loading opera-
		tion.
	SPEED	The speed-prioritized retracting
		control is executed.
		It retracts the paper by the amount
		the paper was advanced.

5-44 User's Manual