Fujitsu DL3750+/3850+ manual Select the Hardwre function, Select an option for the selected item

USING SETUP MODE

Procedure

To change the printer’s hardware options, make sure that continuous forms are loaded and then proceed as follows:

1.Enter setup mode.

Press the TEAR OFF button and the ONLINE button simultaneously until the printer beeps. Wait for the printer to stop printing and check that the following <<FUNCTION>> menu is printed:

<<FUNCTION>>

SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG DEFAULT LIST SELF-TST HEX-DUMP V-ALMNT

2.Select the HARDWRE function.

Repeatedly press the LOAD button or the LF/FF button to position the red cursor under HARDWRE. Press the MENU button to select the HARDWRE function and print the first item and its options, as shown below:

<PPR-OUT> CNTONLY DETECT IGNORE

3.Select an option for the selected item.

Press the LOAD button or the LF/FF button to move the cursor to the option you require. Press the MENU button to select the option and print the next item.

NOTE

To print the previous item, press the TEAR OFF button.

4.Repeat step 3 until all required options are changed.

5.Exit the HARDWRE function.

Press the ONLINE button to exit the HARDWRE function and reprint the <<FUNCTION>> menu.

5-34 User's Manual