Fujitsu DL3750+/3850+ manual Exiting and Saving, Settings are used, Print the Function menu

USING SETUP MODE

EXITING AND SAVING	This section describes how to exit the setup mode save any changes you
	made:
	To exit setup mode immediately, select the SAVE & END function.
	Any settings changed while in setup mode are saved as the new power-on
	defaults for the printer. The new defaults remain active until you change them
	again.
	NOTE
	The only way to exit setup mode without saving your changes is to turn off
	the printer. When you turn the printer back on, the previous default
	settings are used.
	Procedure
	To exit setup mode and save your changes using SAVE & END, proceed as
	follows:
	1. Print the <<FUNCTION>> menu.
	The <<FUNCTION>> menu should be the last printed line on the
	page. If the menu is not printed, press the ONLINE button to print the
	menu. If you are using the SELF-TST or HEX-DUMP function, press
	the LF/FF button instead of the ONLINE button to print the menu.
	The <<FUNCTION>> menu is shown below.
<<FUNCTION>>
SAVE&END MENU1 MENU2	HARDWRE ADJUST CONFIG DEFAULT LIST SELF-TST HEX-DUMP
V-ALMNT
	2. Select the SAVE & END function.
	Make sure that the red cursor is positioned under SAVE & END.
	Press the MENU button or the TEAR OFF button to select SAVE &
	END. The printer exits setup mode and returns online (the ONLINE
	indicator lights green). Any changes you made while in setup mode
	are saved.

5-48 User's Manual