Fujitsu DL3750+/3850+ manual Cutload, Button, Loadtim, Decode, Direct

USING SETUP MODE

Table 5.6 CONFIG Items and Options (Cont.)

NOTE: Underlined options are the factory defaults.

CONFIG Items	Options	Description
<TEAR-EN>		In some application programs, data
(continued)		transfer may stop temporarily due
		to internal processing. This setting can
		avoid an undesired tearoff feed by
		waiting for up to six seconds each time
		data transfer stops.
<CUTLOAD>		Single sheet autoloading.
	AUTO	Single sheet paper is automatically
		loaded a certain time after you set
		the paper.
	BUTTON	Single sheet paper can be loaded by
		pressing the LOAD button.

The following <LOADTIM> item is printed when CUTLOAD:AUTO is specified for the <CUTLOAD> item.

<LOADTIM>		Autoload start time.
	0.5, 1.0,	Autoloading starts when this
	1.5, 2.0	amount of time passes after you set
	2.5, 3.0SEC	single sheet paper.
<DECODE>		Command decode timing.
	DIRECT	The printer decodes certain commands
		immediately after receiving data.
		Example:
		ESC SUB I, ESC CR P (DPL24C+)
		ESC Q # (IBM XL24E)
	QUEUED	The printer decodes commands after
		storing all data (including commands)
		in the input buffer. This speeds data
		reception because the printer does not
		require decoding time during data
		reception.

5-42 User's Manual