Fujitsu DL3750+/3850+ manual Printing a List, Selected Options, Select the List function

USING SETUP MODE

PRINTING A LIST OF	The LIST function prints a list of all the printer’s currently selected options.
SELECTED OPTIONS	This function is useful for checking the printer settings when you first enter
	setup mode or just before you exit. To print a list of options, load continuous
	forms paper and then proceed as follows:
	1. Enter setup mode.
	Place the printer offline. Press the TEAR OFF button and the
	ONLINE button simultaneously until the printer beeps. Wait for the
	printer to stop printing and check that the following <<FUNCTION>>
	menu is printed:
<<FUNCTION>>
SAVE&END MENU1 MENU2	HARDWRE ADJUST CONFIG DEFAULT LIST SELF-TST HEX-DUMP
V-ALMNT
	2. Select the LIST function.
	Repeatedly press the LOAD button or the LF/FF button to position the
	red cursor under LIST. Next press the TEAR OFF button or the
	MENU button to select the LIST function. The printer starts to print a
	list of the currently selected options. The preselected factory settings,
	also called factory defaults, are shown on the opposite page.
	When the printer finishes printing the list of options, it reprints the
	<<FUNCTION>> menu.
	NOTE
	To remove the printout, turn the platen knob until the paper can
	be torn off at the perforation. In setup mode, you cannot use the
	printer tear-off feature (TEAR OFF button).
	3. Do either of the following:
	• Select another function, or
	• Exit setup mode, saving any changes you made.
	For details about other functions, see the other sections in this chapter.
	To exit setup mode and save your changes, make sure that the red
	cursor is positioned beneath SAVE & END, then press the MENU
	button or the TEAR OFF button.

5-10 User's Manual