Fujitsu DL3750+/3850+ manual Setting Up Handling Paper Printing Setup Mode

SETTING UP

7.Align the print head position with the dot mark (green) on the printer ejection cover.

Dot mark (green)

Reference	Quick
Introduction

WARNING

Avoid touching the print head while using or immediately after using the printer, as doing so may lead to burns. Wait until the print head cools down before touching it.

8.Thread the ribbon between the print head and the print guide, then gently press down on the ribbon cartridge against the printer until it clicks into place.

(Make sure that the ribbon feed knob is facing upward.)

Print guide

Print head

Ribbon cartridge

Ribbon

Print guide

Tip of print head

9.Turn the ribbon feed knob clockwise to take up any ribbon slack.

10.After the ribbon cartridge has been installed in the printer, adjust the paper thickness lever to match the thickness of the paper and the number of sheets of paper to be used

For information about the paper thickness lever, see the section entitled Adjusting the Paper Thickness in Chapter 3.

Setting Up

Handling Paper

Printing Setup Mode

User's Manual 2-9