SECTION 8: SERVICE ADJUSTMENTS
Always disconnect power to the machine before performing ser- vice adjustments. Failure to do this may result in serious personal injury.
About Service
This section is designed to help the operator with adjustments that were made at the factory and that might also need to be made during the life of the machine.
This section is provided for your convenience— it is not a substitute for the Grizzly Service Department. If any adjustments arise that are not described in this manual, then feel free to call the Grizzly Service Department at (570)
Similarly, if you are unsure of how to perform any procedure in this section, the Grizzly Service Department will be happy to guide you through the procedures or help in any other way.
Fence Alignment
If the face of the fence is not parallel to the saw blade (cut line), the resulting rip cut will yield a workpiece that is wider at one end or the other.
To adjust the fence alignment:
1.Rip cut a scrap workpiece.
2.Measure the width at each end of a workpiece that has been cut on the rip saw.
—If end A is wider than end B, then the tip of the fence needs to be adjusted to the left to make the fence parallel to the blade (Figure 26).
A
B
Figure 26. Adjusting the fence to the left.
G0524 Rip Saw |