TROUBLESHOOTING
Problem |
| Possible Solution |
Air leak near top of tool. | 1. Tighten all screws on the cylinder cap. (See Assy. Diagram.) | |
| 2. | Have a qualified service technician install a head valve piston set. |
Tool does not work. | 1. Make sure the compressor regulator is set at 90 PSI. (See page 6.) | |
| 2. | Check all air connections for leaks. |
| 3. | Make sure to fully depress the nose on the workpiece when |
|
| attempting to fire a nail. (See page 7.) |
| 4. | Check for nail jams. Clear the jam if necessary. (See pages 9 & 10) |
| 5. | Have a qualified service technician check out the tool. |
Sluggish operation. | 1. Make sure the compressor regulator is set at 90 PSI. Make sure | |
| compressor used produces sufficient C.F.M. to operate the Nailer. | |
| 2. | Check all air connections for leaks. |
| 3. | Have a qualified service technician install a head valve piston set. |
Air leak near bottom of tool. | 1. Tighten all screws. | |
| 2. | Have a qualified service technician replace the bumper or head |
|
| Valve piston set. |
Poor return after firing tool. | 1. Have a qualified service technician clean the interior of the tool and/or | |
|
| Replace the bumper or head valve piston set. |
Weak driving force. | 1. Make sure the compressor regulator is set at 90 PSI. | |
| 2. | Check all air connections for leaks. |
| 3. | Have a qualified service technician clean the interior of the tool and/or |
|
| Replace the bumper or head valve piston set. |
Poor feed. | 1. Have a qualified service technician clean the interior of the tool and/or | |
|
| Lubricate the magazine and install a new magazine spring. |
Too jamming too often. | 1. Have a qualified service technician clean the interior of the tool and/or | |
|
| Lubricate the magazine and install a new magazine spring. |
Other problems. | 1. Have a qualified service technician check out the tool. | |
SKU 93760 | For technical questions, please call | PAGE 11 |