Global Machinery Company ATBR1650-3PK instruction manual Troubleshooting

Page 15

Troubleshooting

Trouble

Possible cause

Suggested remedy

 

 

 

Fires two nails at time.

The head of the nail is too small

Check nail size.

 

(Head size should be 2.8mm - 3.3mm).

 

 

 

 

 

18 gauge nails have been fitted.

Purchase correct size nails from your

 

 

local Air Tool supplier.

 

 

 

Nailer skips when driving

Dirt in the nose piece.

Drive channel needs to be cleaned.

brad nails.

 

 

Dirt or damage prevent nails or pusher

Magazine needs to be cleaned.

 

 

from moving freely in magazine.

 

 

 

 

 

Inadequate air flow to nailer.

The fittings, hose or air compressors

 

 

needs to be checked.

 

 

 

Air leaking near the top of

Loose screws.

Tighten screws.

the tool or in trigger area.

Worn or damaged o-rings or bumper.

 

 

 

 

Nailer runs slow or has

Nailer not lubricated sufficiently.

Nailer needs to be lubricated.

loss of power.

 

 

Exhaust port in the cap has been blocked.

Damaged internal parts needs to be

 

 

 

replaced by an authorized service centre.

 

 

 

Air leaking near the bottom

Loose screws.

Tighten screws.

of the tool.

Worn or damaged o-rings or bumper.

 

 

 

 

Tool jams frequently.

Incorrect fasteners.

Verify approved fasteners of correct size.

 

Damaged fasteners.

Replace with undamaged fasteners.

 

 

 

 

Magazine is dirty.

Clean magazine.

 

 

 

 

Magazine or nose screw loose.

Tighten screws.

 

 

 

WARNING: Disconnect tool from air supply before performing any cleaning and maintenance procedures.

15

Image 15
Contents Finishing Nail GUN KIT Contents Environmental protection Description of symbolsSpecifications IntroductionGeneral safety instructions for air tools Page Important safety instructions Risk of eye or head injury What could happen How to prevent itRisk of fire or explosion Risk to injury Risk of loss of hearingRepair servicing should be done only by an authorized Risk of electric shock Risk of cut or burns Risk of entanglementKnow your product Tool lubrication Preparing the toolOperating the tool Firing mechanism Where to use finishing nailerChecking the safety strike element OperationClearing a jam Adjusting the exhaust directionAdjusting the fastening depth Air sourceTroubleshooting Magnesium Brad NAILER/STAPLER GUN Contents Introduction General safety instructions for air tools Page Important safety instructions Risk of eye or head injury Risk of loss of hearing Repair servicing should be done only by an authorized Risk of electric shock Risk of entanglement Know your product Preparing the tool Where to use brad nailer/stapler Air source Nailer/stapler runs slow or Has loss of powerNailer/stapler skips when Driving brad nails/staplesFraming GUN KIT Contents Nails General safety instructions Additional safety rules for framing gun nailers Page Important safety instructions Risk of eye or head injury Risk of loss of hearing Repair servicing should be done only by an authorized Risk of electric shock Risk of entanglement Non marking tip Air inlet not shown Selecting air hose Tool lubrication Selecting compressorSingle full sequential actuation firing Where to use framing nailerAdjusting depth of nailing Operating the toolMaintenance Connecting the air hoseMaintenance of nailer Cleaning Maintenance of compressor, air settings and air hoseRepairs Air leaking near Trouble Possible cause Suggested remedy Nailer skips whenDriving nails Tool or in trigger area Nailer runs slow or has