Global Machinery Company ATBR1650-3PK Nailer/stapler skips when, Driving brad nails/staples

Page 30

Troubleshooting

	Trouble	Possible cause	Suggested remedy

	Fires two nails at time.	The head of the nail is too small	Check nail/staple size.
		(Nail head size should be 1.9mm - 2.2mm
		and staple crown should be 5.7mm).

		16 gauge nails have been fitted.	Purchase correct size nails from your
			local Air Tool supplier.

	Nailer/stapler skips when	Dirt in the nose piece.	Drive channel needs to be cleaned.
	driving brad nails/staples.
	driving brad nails/staples.	Dirt or damage prevent nails or pusher	Magazine needs to be cleaned.
		Dirt or damage prevent nails or pusher	Magazine needs to be cleaned.
		from moving freely in magazine.

		Inadequate air flow to nailer/stapler.	The fittings, hose or air compressors
			needs to be checked.

	Air leaking near the top of	Loose screws.	Tighten screws.
	the tool or in trigger area.	Worn or damaged o-rings or bumper.

	Nailer/stapler runs slow or	Nailer/stapler not lubricated sufficiently.	Nailer/stapler needs to be lubricated.
	has loss of power.
	has loss of power.	Exhaust port in the cap has been blocked.	Damaged internal parts needs to be
		Exhaust port in the cap has been blocked.	Damaged internal parts needs to be
			replaced by an authorized service centre.

	Air leaking near the bottom	Loose screws.	Tighten screws.
	of the tool.	Worn or damaged o-rings or bumper.

	Tool jams frequently.	Incorrect fasteners.	Verify approved fasteners of correct size.

		Damaged fasteners.	Replace with undamaged fasteners.

		Magazine is dirty.	Clean magazine.

		Magazine or nose screw loose.	Tighten screws.

WARNING: Disconnect tool from air supply before performing any cleaning and maintenance procedures.

15

Image 30

Contents Finishing Nail GUN KIT Contents Introduction Description of symbolsSpecifications Environmental protectionGeneral safety instructions for air tools Page Important safety instructions Risk of eye or head injury What could happen How to prevent itRisk of fire or explosion Risk of loss of hearing Risk to injuryRepair servicing should be done only by an authorized Risk of electric shock Risk of entanglement Risk of cut or burnsKnow your product Preparing the tool Tool lubricationOperation Where to use finishing nailerChecking the safety strike element Operating the tool Firing mechanismAir source Adjusting the exhaust directionAdjusting the fastening depth Clearing a jamTroubleshooting Magnesium Brad NAILER/STAPLER GUN Contents Introduction General safety instructions for air tools Page Important safety instructions Risk of eye or head injury Risk of loss of hearing Repair servicing should be done only by an authorized Risk of electric shock Risk of entanglement Know your product Preparing the tool Where to use brad nailer/stapler Air source Driving brad nails/staples Has loss of powerNailer/stapler skips when Nailer/stapler runs slow orFraming GUN KIT Contents Nails General safety instructions Additional safety rules for framing gun nailers Page Important safety instructions Risk of eye or head injury Risk of loss of hearing Repair servicing should be done only by an authorized Risk of electric shock Risk of entanglement Non marking tip Air inlet not shown Selecting compressor Selecting air hose Tool lubricationOperating the tool Where to use framing nailerAdjusting depth of nailing Single full sequential actuation firingMaintenance Connecting the air hoseMaintenance of nailer Cleaning Maintenance of compressor, air settings and air hoseRepairs Tool or in trigger area Nailer runs slow or has Trouble Possible cause Suggested remedy Nailer skips whenDriving nails Air leaking near