Woodstock W1751 owner manual Unpacking, Box Contents

Page 12

W1751 25" Wide-Belt Sander

SET UP

Unpacking

SET UP

The Model W1751 has been carefully packaged for safe transporting. If you notice the machine has been damaged in shipment, contact your machine dealer and the shipping company immediately.

Box Contents

The following is a description of the components shipped with the Shop Fox W1751. Lay the components out, and use Figure 2 and the list below to inventory your package. If any parts are missing, find the part number in the back of this manual and call Woodstock International, Inc. at 360-734-3482 or e-mail: tech-support@shopfox.biz.

Item	Qty.
Wide Belt Sander	1
Sanding Belt 100 Grit	1
Sanding Belt 180 Grit	1
Platen Assembly	1
Crank Handle	1
Tool Box	1
—Phillips Head Screwdriver #2	1
—Open-End Wrench 8/10mm	1
—Open-End Wrench 12/14mm	1
—Open-End Wrench 11/13mm	1
—Open-End Wrench 17/19mm	1
—Special Wrench	1
—10 Pc-Metric Hex Wrench Set	1
—Door Lever Keys	2
—Platen Removal Tool	1

SUFFOCATION
HAZARD!
Immediately	discard
all plastic	bags	and
packing materials		to
eliminate	choking/
suffocation hazards for
children and animals.

The Model W1751 weighs approximately 1060 lbs. Use power or hydraulic equipment to avoid serious personal injury or death.

Figure 2. Parts and tool inventory.

-10-

Image 12

Contents WIDE-BELT Sander Page Contents Service Introduction Woodstock Technical SupportSpecifications Controls and Features Standard Safety Instructions Disconnect machine when cleaning, adjusting or servicingKeep stable footing and balance at all times Additional Safety Instructions for Sanders 220V Operation Extension CordsGrounding Box Contents UnpackingMachine Placement Cleaning MachineAssembly PlatenHandwheel Crank Air Supply DuctingSanding Belt Installation Sanding Belt TensioningTo adjust the pressure rollers, do these steps Pressure Roller Depth and AlignmentPressure roller adjuster Pressure Roller TensionControl Panel Conveyor Belt Start and Stop ButtonsSanding Load Amp Meter Sanding Belt Start and Stop ButtonsGeneral Operation Test RunTo complete the test run, do these steps Setting Feed Speed Using the Amp Draw MeterTo change the conveyor belt speed do these steps Changing Sanding Belts Emergency StopTo use the emergency stop, do these steps Using the Platen Basic SandingTip To sand a workpiece, do these stepsOperations To adjust the jet air flow, do these steps Jet Air FlowBelt Tracking Belt tracking knob and leverBelt Tracking procedure on Page 24 or the Jet Belt Oscillation SpeedCleaning Belts GeneralLubrication Maintaining Air SystemBrake Service To check the condition of the brake pads, do these stepsTo replace the brake pads, do these steps Changing V-Belts Change the V-belt as followsBelt Tension To tension the V-belts, do these stepsConveyor belt tension Tracking adjustment locations Conveyor Belt Tension TrackingPressure Rollers Gauge boards placed under Pressure rollersBelt Tracking Limit Switch To adjust the belt tracking limit switches, do these stepsTroubleshooting Motor & ElectricalSanding and Results Electrical Box Component Locations See FigureEmergency Power lamp Digital ampW1751 Limit Switch Wiring Diagram W1751 General Wiring Diagram Sanding Motor Parts List PART# DescriptionConveyor System Conveyortable Upper Contactrollerbase Sanding DrumSystem BALLBEARING6005ZZ Upper Machineframe Air System Parts List PartsElectrical Connections Box DescriptionAccessories Accessories List Label Placement Labels ListWarranty Warranty Registration CommentsBOX BELLINGHAM, WA