Woodstock W1751 Control Panel, Conveyor Belt Start and Stop Buttons, Sanding Load Amp Meter

Page 19

W1751 25" Wide-Belt Sander

OPERATIONS

Control Panel

Below is a summary of your sander control panel and	• Power Lamp: Indicates when machine has
the components that it controls. Use the list with	power to the control panel.
Figure 12 to become familiar with your sander.	• Conveyor Belt Start and Stop Buttons:
	• Conveyor Belt Start and Stop Buttons:
• Sanding Load Amp Meter:	Cycles the conveyor motor ON and OFF for
Indicates the amp load on the sanding motor when	feeding wood into the sander.
a sanding operation is in progress. Never operate	• Emergency Stop Button: Stops all electrical
the sander in the red zone.	• Emergency Stop Button: Stops all electrical
• Sanding Belt Start and Stop Buttons:	power to motors in event of emergency,
• Sanding Belt Start and Stop Buttons:	and stops sanding drums with an air-disc
Turns the sanding motor ON and OFF if the sander	brake. If button was pushed, you must
has air pressure and the belt is tensioned.	rotate the button so it pops back out, and
	then you can start the machine again.

Sanding

Load

Amp

Meter

Emergency

Stop

Button

Sanding

Belt

Start

Button

Conveyor Belt

Start

Button

OPERATIONS


Power
Lamp
Lamp		Sanding			Conveyor Belt


		Belt Stop				Stop
		Button				Button

Figure 12. Control panel interface.

-17-

Image 19

Contents WIDE-BELT Sander Page Contents Service Woodstock Technical Support IntroductionSpecifications Controls and Features Disconnect machine when cleaning, adjusting or servicing Standard Safety InstructionsKeep stable footing and balance at all times Additional Safety Instructions for Sanders Extension Cords 220V OperationGrounding Unpacking Box ContentsCleaning Machine Machine PlacementPlaten AssemblyHandwheel Crank Ducting Air SupplySanding Belt Tensioning Sanding Belt InstallationPressure Roller Depth and Alignment To adjust the pressure rollers, do these stepsPressure Roller Tension Pressure roller adjusterSanding Belt Start and Stop Buttons Control PanelConveyor Belt Start and Stop Buttons Sanding Load Amp MeterTest Run General OperationTo complete the test run, do these steps Using the Amp Draw Meter Setting Feed SpeedTo change the conveyor belt speed do these steps Emergency Stop Changing Sanding BeltsTo use the emergency stop, do these steps To sand a workpiece, do these steps Using the PlatenBasic Sanding TipOperations Jet Air Flow To adjust the jet air flow, do these stepsBelt tracking knob and lever Belt TrackingBelt Oscillation Speed Belt Tracking procedure on Page 24 or the JetMaintaining Air System Cleaning BeltsGeneral LubricationTo check the condition of the brake pads, do these steps Brake ServiceTo replace the brake pads, do these steps Change the V-belt as follows Changing V-BeltsTo tension the V-belts, do these steps Belt TensionConveyor Belt Tension Tracking Conveyor belt tension Tracking adjustment locationsGauge boards placed under Pressure rollers Pressure RollersTo adjust the belt tracking limit switches, do these steps Belt Tracking Limit SwitchMotor & Electrical TroubleshootingSanding and Results See Figure Electrical Box Component LocationsEmergency Digital amp Power lampW1751 Limit Switch Wiring Diagram W1751 General Wiring Diagram Sanding Motor PART# Description Parts ListConveyor System Conveyortable Upper Contactrollerbase Sanding DrumSystem BALLBEARING6005ZZ Upper Machineframe Parts Air System Parts ListDescription Electrical Connections BoxAccessories Accessories List Labels List Label PlacementWarranty Comments Warranty RegistrationBOX BELLINGHAM, WA