Woodstock W1751 owner manual Pressure Roller Tension, Pressure roller adjuster

Page 18

W1751 25" Wide-Belt Sander

SET UP

Pressure Roller Tension

Pressure roller tension is the downward force that the pressure rollers place on the workpiece as it passes through the sander. Too little tension will cause the workpiece to pass unevenly through the sander and may launch the workpiece from the sander. Too much tension may cause poor and inconsistent sanding results, as well as premature wear on the conveyor belt and table.

To adjust the pressure rollers, do these steps:

1.MAKE SURE THE MACHINE IS DISCONNECTED FROM POWER and that you have set the pressure roller height.

2.Open both upper access doors and locate the four tension springs shown in Figure 11.

3.The position of the tension adjustment nut (Figure 11) controls the spring tension. Turn the nut clock- wise to increase the tension and counterclockwise to decrease the tension.

Tension

Adjustment

Nut

Spring

Figure 11. Pressure roller adjuster.

-16-

Image 18
Contents WIDE-BELT Sander Page Contents Service Introduction Woodstock Technical SupportSpecifications Controls and Features Standard Safety Instructions Disconnect machine when cleaning, adjusting or servicingKeep stable footing and balance at all times Additional Safety Instructions for Sanders 220V Operation Extension CordsGrounding Box Contents UnpackingMachine Placement Cleaning MachineAssembly PlatenHandwheel Crank Air Supply DuctingSanding Belt Installation Sanding Belt TensioningTo adjust the pressure rollers, do these steps Pressure Roller Depth and AlignmentPressure roller adjuster Pressure Roller TensionSanding Load Amp Meter Control PanelConveyor Belt Start and Stop Buttons Sanding Belt Start and Stop ButtonsGeneral Operation Test RunTo complete the test run, do these steps Setting Feed Speed Using the Amp Draw MeterTo change the conveyor belt speed do these steps Changing Sanding Belts Emergency StopTo use the emergency stop, do these steps Tip Using the PlatenBasic Sanding To sand a workpiece, do these stepsOperations To adjust the jet air flow, do these steps Jet Air FlowBelt Tracking Belt tracking knob and leverBelt Tracking procedure on Page 24 or the Jet Belt Oscillation SpeedLubrication Cleaning BeltsGeneral Maintaining Air SystemBrake Service To check the condition of the brake pads, do these stepsTo replace the brake pads, do these steps Changing V-Belts Change the V-belt as followsBelt Tension To tension the V-belts, do these stepsConveyor belt tension Tracking adjustment locations Conveyor Belt Tension TrackingPressure Rollers Gauge boards placed under Pressure rollersBelt Tracking Limit Switch To adjust the belt tracking limit switches, do these stepsTroubleshooting Motor & ElectricalSanding and Results Electrical Box Component Locations See FigureEmergency Power lamp Digital ampW1751 Limit Switch Wiring Diagram W1751 General Wiring Diagram Sanding Motor Parts List PART# DescriptionConveyor System Conveyortable Upper Contactrollerbase Sanding DrumSystem BALLBEARING6005ZZ Upper Machineframe Air System Parts List PartsElectrical Connections Box DescriptionAccessories Accessories List Label Placement Labels ListWarranty Warranty Registration CommentsBOX BELLINGHAM, WA