Woodstock W1751 owner manual Operations

Page 24

W1751 25" Wide-Belt Sander

7.While standing out of the way of potential kick back, place the workpiece on the conveyor and allow the conveyor to pull the workpiece in.

8.Observe the amp load gauge.

—If the amps begin to climb to the red zone, IMMEDIATELY rotate the handwheel so the table is lowered and the sanding depth is reduced.

9.Receive the workpiece from the outfeed side of the conveyor, measure the workpiece, readjust the sanding depth, and make a second sanding path while watching the amp load gauge.

10.Repeat as required to get your sanding results.

Note: To get good sanding results you will almost always need to make two to three sanding passes.

OPERATIONS

-22-

Image 24

Contents WIDE-BELT Sander Page Contents Service Introduction Woodstock Technical SupportSpecifications Controls and Features Standard Safety Instructions Disconnect machine when cleaning, adjusting or servicingKeep stable footing and balance at all times Additional Safety Instructions for Sanders 220V Operation Extension CordsGrounding Box Contents UnpackingMachine Placement Cleaning MachineAssembly PlatenHandwheel Crank Air Supply DuctingSanding Belt Installation Sanding Belt TensioningTo adjust the pressure rollers, do these steps Pressure Roller Depth and AlignmentPressure roller adjuster Pressure Roller TensionControl Panel Conveyor Belt Start and Stop ButtonsSanding Load Amp Meter Sanding Belt Start and Stop ButtonsGeneral Operation Test RunTo complete the test run, do these steps Setting Feed Speed Using the Amp Draw MeterTo change the conveyor belt speed do these steps Changing Sanding Belts Emergency StopTo use the emergency stop, do these steps Using the Platen Basic SandingTip To sand a workpiece, do these stepsOperations To adjust the jet air flow, do these steps Jet Air FlowBelt Tracking Belt tracking knob and leverBelt Tracking procedure on Page 24 or the Jet Belt Oscillation SpeedCleaning Belts GeneralLubrication Maintaining Air SystemBrake Service To check the condition of the brake pads, do these stepsTo replace the brake pads, do these steps Changing V-Belts Change the V-belt as followsBelt Tension To tension the V-belts, do these stepsConveyor belt tension Tracking adjustment locations Conveyor Belt Tension TrackingPressure Rollers Gauge boards placed under Pressure rollersBelt Tracking Limit Switch To adjust the belt tracking limit switches, do these stepsTroubleshooting Motor & ElectricalSanding and Results Electrical Box Component Locations See FigureEmergency Power lamp Digital ampW1751 Limit Switch Wiring Diagram W1751 General Wiring Diagram Sanding Motor Parts List PART# DescriptionConveyor System Conveyortable Upper Contactrollerbase Sanding DrumSystem BALLBEARING6005ZZ Upper Machineframe Air System Parts List PartsElectrical Connections Box DescriptionAccessories Accessories List Label Placement Labels ListWarranty Warranty Registration CommentsBOX BELLINGHAM, WA